Network And Connect Line Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Select "Network/Connect Line Check" on "Service" screen.

Fig 1: Scan Tool Display - Network/Connect Line Check
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
A network and connect line check will be initiated. The "Network/Connect Line Check" screen will display how the check is in progress.

Fig 2: Scan Tool Display - Network/Connect Line Check
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When the network and connect line check is finished, the screen will change to "Network/Connect Line Result" to show the check results.

Fig 3: Scan Tool Display - Network/Connect Line Result
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

NOTE: If there is "NG" or "N/A" as the check results, select "NG Code" on the "Network/Connect Line Result" screen. Then "NG code Indication" screen will show the NG code.

Fig 4: Scan Tool Display - NG Code Indication
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If "Back" is selected on "Network/Connect Line Result", the screen will return to "Service" screen.