LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Chassis Electrical - Lancer Evolution (3 Of 5)) >> MMCS >> Diagnosis >> Service Mode >> Monitor Check

Monitor Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Select "Monitor Check" on "Service" screen.
    Fig 1: Scan Tool Display - Vehicle Signal Check
    G05396995Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Scan Tool Display - Monitor Check
    G05385459Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Eight color bars will be displayed.
    Fig 3: Scan Tool Display - Eight Color Bars
    G05385464Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. When "Enter" is pressed on the navigation unit joystick while the eight color bars are shown, gray scale will be displayed with a 16-step gradation.
    Fig 4: Scan Tool Display - Eight Color Bars
    G05385465Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. When "Enter" is pressed while the gray scale is shown with a 16-step gradation, a crosshatch pattern will be displayed (Each cell should be square).
    Fig 5: Scan Tool Display - Crosshatch Pattern
    G05385466Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. When "Enter" is pressed on the navigation unit joystick while the crosshatch pattern is shown, the screen will turn white.
    Fig 6: Scan Tool Display - White Screen
    G05385467Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. When "Enter" is pressed on the navigation unit joystick while the screen is white, it will turn black.
    Fig 7: Scan Tool Display - Black Screen
    G05385468Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  7. When "Enter" is pressed on the navigation unit joystick while the screen is black, the screen will turn red.
    Fig 8: Scan Tool Display - Red Screen
    G05385469Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  8. When "Enter" is pressed on the navigation unit joystick while the screen is red, it will turn green.
    Fig 9: Scan Tool Display - Green Screen
    G05385470Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  9. When "Enter" is pressed on the navigation unit joystick while the screen is green, it will turn blue.
  10. When "Enter" is pressed on the navigation unit joystick while the screen is green, it will return to the "Service" screen.
    Fig 10: Scan Tool Display - Blue Screen
    G05385471Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.