How To Terminate The Service Mode

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

If the operations below are done, the service mode will be terminated.

If "Back" button is selected on "Service" screen, the service mode will terminate and then return to the previous screen.
If "NAVI" button is pressed with the service mode active, the service mode will terminate and change to the navigation screen.

Fig 1: Scan Tool Display - NAVI And SET Buttons
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
NOTE:
If "NAVI" button is pressed, the following functions of the service mode will terminate.
- Vehicle Signal Check
- Monitor Check
- Network/Connect Line Check
- Speaker Check
- Versions Indication
- Sensor Check
- Touch Switch Confirmation
- CAN communication Confirmation
- Memory Initialization
- Versions Log Information
  
  Fig 2: Scan Tool Display - Back Button
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.