Windshield Intermittent Wiper Interval Check
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- Check that the intermittent wiper interval is changed as the windshield intermittent wiper interval control is operated.
- Turn the windshield intermittent wiper switch to the intermittent operation position. Use scan tool MB991958 to set a simulated vehicle speed with the wiper volume held. The intermittent wiper interval should be changed as the simulated vehicle speed is changed.
- If either of above is defective, carry out the troubleshooting. (Refer to INSPECTION PROCEDURE 5: THE WINDSHIELD INTERMITTENT WIPER INTERVAL CANNOT BE ADJUSTED BY OPERATING THE WINDSHIELD INTERMITTENT WIPER INTERVAL CONTROL SWITCH. )