Technical Description (Comment)
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
There is a failure in the wiring harness between the combination meter and the multivision display, the GPS antenna, the respective connector(s), the combination meter or the multivision display.
NOTE:
- If the vehicle speed signal has a problem, the speedometer of combination meter will be affected. Confirm if the speedometer of combination meter works normally at the abnormal state to customers.
- When the own vehicle mark position becomes deviated when travelling backward, a problem may be present to the reverse signal from the transmission range switch to multivision display. In this case, check if the rear view camera is operating normally. If there is a problem, troubleshoot the rear view camera. (Refer to INSPECTION PROCEDURE 1: REAR VIEW CAMERA IMAGE IS NOT CORRECTLY DISPLAYED < VEHICLES WITH MMCS > .) Subsequently, carry out this troubleshooting.