LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Intake & Exhaust System - Lancer >> EXHAUST PIPE AND MAIN MUFFLER - 2.0L ENGINE Non-turbo, 2.4L ENGINE >> Removal And Installation >> Removal Service Points >> << B >> Rivet Removal

<< B >> Rivet Removal

CAUTION: Be careful not to score the heat protector by drill.

Use a 6.0/diameter/mm drill to make a hole in the rivet to break it, and then remove the rivet.

Fig 1: Drilling Hole In Rivet
G05375383Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals