LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Intake & Exhaust System - Lancer >> EXHAUST MANIFOLD AND TURBOCHARGER - 2.0L ENGINE Turbo >> Removal And Installation >> Installation Service Points >> >> E << Turbocharger Exhaust Outlet Fitting Bracket Installation

>> E << Turbocharger Exhaust Outlet Fitting Bracket Installation

  1. Check that the turbocharger exhaust outlet fitting bracket is in close contact with the turbocharger exhaust outlet fitting and with the cylinder block, and then temporarily tighten the turbocharger exhaust outlet fitting bracket mounting bolts.
  2. Tighten the bolt of the cylinder block side to the specified torque.

    Tightening torque: 51 ± 7 N.m (38 ± 5 ft-lb) 

  3. Tighten the bolt of the turbocharger exhaust outlet fitting bracket side to the specified torque.

    Tightening torque: 64 ± 5 N.m (48 ± 3 ft-lb) 

    Fig 1: Identifying Turbocharger Exhaust Outlet Fitting Bracket
    G05903586Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals