LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System - Lancer >> Water Hose And Water Pipe >> Removal And Installation - 2.0L Engine Turbo >> Installation Service Points >> >> B << Fuel High-Pressure Hose Connection

>> B << Fuel High-Pressure Hose Connection

  1. Pull up the retainer of fuel high-pressure hose to unlock before installing.
    Fig 1: Pulling Up Retainer Of Fuel High-Pressure Hose
    G05430032Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Securely insert the fuel rail stopper into the fuel high-pressure hose connector groove to install the fuel high-pressure hose to the fuel rail.
    CAUTION:
    • When pushing in the retainer of the fuel high-pressure hose connector, pay attention to avoid damage to the retainer.
    • After the installation of the fuel high-pressure hose, slightly pull the fuel high-pressure hose to check that it is connected securely. At this time, also check that there is approximately 1 mm (0.04inch) play.
    Fig 2: Installing Fuel High-Pressure Hose To Fuel Rail
    G05375313Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Push in the retainer of the fuel high-pressure hose connector to lock the fuel high-pressure hose and fuel rail.
scientia non olet · About LEMON Manuals