LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Axle - Lancer >> Driveshaft Assembly >> Removal And Installation >> Installation Service Points >> >> B << Stabilizer Link Connection

>> B << Stabilizer Link Connection

Use a hexagon wrench to install the stabilizer link and strut connection nut as shown in the illustration.

Fig 1: Removing Stabilizer Link And Strut Connection Nut Using Hexagon Wrench
G06672538Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals