LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Braking System (Abs) - With Diagnostics - Lancer >> Abs Diagnosis >> Check At Ecu Terminals >> Resistance And Continuity Between Harness-Side Connector Terminals

Resistance And Continuity Between Harness-Side Connector Terminals

Required Special Tool: 

MB991974: ABS Check Harness

  1. When performing the continuity check, turn the ignition switch to LOCK (OFF) position, connect the special tool ABS check harness (MB991974) as shown in illustration, and disconnect the ABS-ECU connector.
  2. Check for continuity between terminals shown in the chart below.
  3. Terminal layout is shown in illustration.
Terminal No. Signal Normal conditions
1 - body ground Ground Continuity exists (2 Ω or less)
14 - body ground Ground Continuity exists (2 Ω or less)
scientia non olet · About LEMON Manuals