LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Brakes >> Traction Control >> Active Stability Control System (ASC) - With Diagnostics - Lancer >> Diagnosis >> Check At Ecu Terminals >> Continuity Check At Wiring Harness-Side Connector

Continuity Check At Wiring Harness-Side Connector

  1. When performing the continuity check, turn the ignition switch to LOCK (OFF) position, connect the special tool ASC check harness (MB991997) as shown in the illustration, and disconnect the ASC-ECU connector.
  2. Check for continuity between terminals shown in the chart below.
  3. Terminal layout is shown in the illustration.
    Fig 1: Checking Wiring Harness-Side Connector Continuity
    G05904955Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Terminal No. Signal Normal condition
16 - body ground Ground Continuity exists (2Ω or less)
47 - body ground Ground
scientia non olet · About LEMON Manuals