LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brakes - Lancer >> Parking Brake Lever >> Removal And Installation >> Installation Service Point >> >> A << Parking Brake Rear Cable Connection Installation

>> A << Parking Brake Rear Cable Connection Installation

CAUTION: Check that the equalizer and the parking brake rear cable are connected correctly. If the parking brake is applied with the equalizer and the parking brake rear cable connected improperly, the equalizer may be damaged.
  1. Connect the parking brake rear cable to the equalizer as shown in the illustration.
    Fig 1: Connecting Parking Brake Rear Cable To Equalizer
    G07034017Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the parking brake rear cable connection, and then tighten the floor console bracket rear mounting bolts to the specified torque.

    Tightening torque: 9.5 ± 3.5 N.m (84 ± 30 in-lb) 

    Fig 2: Floor Console Bracket Rear Mounting Bolts With Torque Specifications
    G05394744Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals