LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Basic Brake System - Lancer >> On-Vehicle Service >> Brake Pedal Check And Adjustment >> Brake Pedal-To-Floor Panel Clearance Check And Adjustment

Brake Pedal-To-Floor Panel Clearance Check And Adjustment

  1. Turn up the floor carpet under the brake pedal.
  2. Start the engine and depress the brake pedal with approximately 500 N, and measure clearance between the brake pedal and the floor panel.

    Standard value (E): 85 mm (3.35 inches) or more 

  3. When the clearance is not within the standard value, check for air in the brake line and thickness of the disc brake pad, and correct or replace as necessary.
  4. Recover the floor carpet under the brake pedal.
    Fig 1: Checking Pedal Stroke Height Standard Value (E)
    G06472279Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals