LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Trunk Lid - Lancer >> On-Vehicle Service >> Trunk Lid Height Adjustment >> Adjustment At Trunk Lid Hinge-Side < RALLIART >

Adjustment At Trunk Lid Hinge-Side < RALLIART >

If the height between the trunk lid and the body is uneven, adjust the height in the following manner.

  1. Remove the trunk lid damper on the trunk lid hinge.
    CAUTION: Up to maximum 3 washers can be used.
  2. Increase or decrease the number of washers until the even height between the trunk lid and the body can be obtained.
  3. Tighten the trunk lid damper.

    Specified torque: 5.0 ± 1.0 N.m (44 ± 8 in-lb) 

    Fig 1: Removing Trunk Lid Damper
    G09627660Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals