Customization Function
By operating the ETACS system or MMCS of scan tool MB991958, the following functions can be programmed. The programmed information is held even when the battery is disconnected.
| Adjustment item (scan tool MB991958 display) | Adjustment item | Adjusting contents (scan tool MB991958 display) | Adjusting contents |
|---|---|---|---|
| Intermittent time of rear wiper | Adjustment of rear wiper interval | 0 sec | No wiper interval |
| 4 sec | 4 seconds | ||
| 8 sec | 8 seconds (initial condition) | ||
| 16 sec | 16 seconds | ||
| Rear wiper low speed mode | Disabling or enabling rear wiper continuous operation | Disabled | No function (initial condition) |
| Enabled | With function | ||
| Rear wiper (linked activated when in reverse | Adjustment of automatic rear window wiper operation with reverse gear engaged | Enable (R wip. ON) | Operates only when the rear wiper switch is ON. |
| Enable (R/F wip.) | Operates only when the front or rear wiper switch is ON (initial condition). |