External Device Connection Check

Select "Ext. Device Conn. Check" button on "Unit Diagnosis" screen.

Fig 1: Display - Unit Diagnosis Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
"Now checking the external device connection." will appear, and then it will switch to "External Device Connection Result" screen.
- If the connection with an equipment is detected, "OK" will be displayed.
- If the connection with an equipment is not detected, "-" will be displayed.
- In case other than above, "NG" is displayed.
  
  Fig 2: Display - Now Checking External Device Connection Screen
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  
  Fig 3: Display - External Device Connection Result Screen
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If "NG" is displayed on the check result screen, "NG code" will be displayed by pressing the respective button on "External Device Connection Result" screen.
NOTE: If "NG" is not displayed at all, "NG code" button is not active.

Fig 4: Display - NG Code Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.