LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Speaker - Lancer >> On-Vehicle Service >> Speaker Test >> < Vehicles with 1CD audio > >> Speaker Connection Check Mode

Speaker Connection Check Mode

With the speaker connection check mode, the connection status of each speaker can be checked based on the sound output from each speaker. The procedure is as follows.

NOTE: If a button other than the button D is pressed, or the ignition switch is turned to "LOCK" (OFF) position, you will exit from the speaker connection check mode.
Fig 1: Speaker Connection Check Mode Flow Diagram
G09630516Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. At the same time with the start of speaker check mode, the sound for speaker connection check is output from the front door speaker (LH) and tweeter (LH).
  2. Press the button D to switch the sound output for speaker connection check from the front door speaker (RH) and tweeter (RH).
  3. Press the button D to switch the sound output for speaker connection check from the rear door speaker (LH).
  4. Press the button D to switch the sound output for speaker connection check from the rear door speaker (RH).
scientia non olet · About LEMON Manuals