LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Hands Free Module - Lancer >> Symptom Procedures >> Inspection Procedure 3: When the speech switch is pressed, the voice information is output, but the voice recognition is not performed. < Vehicles with radio and CD player > >> Diagnosis

Inspection Procedure 3: When the speech switch is pressed, the voice information is output, but the voice recognition is not performed. < Vehicles with radio and CD player >: Diagnosis

Required Special Tools: 

  1. STEP 1. Check the diagnosis mode 

    Q: Is the check result normal? 

    • YES:  Go to  Step 4.
    • NO:  Go to Step 2.
  2. STEP 2. Check hands free module connector C-110 and microphone unit D-03 for loose, corroded or damaged terminals, or terminals pushed back in the connector. 

    Q: Are hands free module connector C-110 and microphone unit connector D-03 in good condition? 

  3. STEP 3. Check the wiring harness between hands free module connector C-110 (terminal 14, 28) and microphone unit connector D-03 (terminal 2, 1). 
    • Check the signal lines for open circuit and short circuit.
    NOTE: Also check intermediate connectors C-130 and C-148 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate connector C-130 and C-148 is damaged, repair or replace the connector as described in HARNESS CONNECTOR INSPECTION .

    Q: Is the wiring harness between hands free module connector C-110 (terminal 14, 28) and microphone unit connector D-03 (terminal 2, 1) in good condition? 

    • YES:  Go to Step 4.
    • NO:  The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the connector. Repair the wiring harness as necessary.
  4. STEP 4. Replace the microphone unit temporarily, and check the trouble symptom. 

    Q: Is the check result normal? 

    • YES:  Replace the microphone unit.
    • NO:  Go to Step 5.
  5. STEP 5. Replace the hands free module temporarily, and check the trouble symptom. 

    Q: Is the check result normal?