Cruise Control System - With Diagnostics - Lancer
- General Information
- Cruise Control System Diagnosis
- Diagnostic Function
- Diagnostic Trouble Code Table (DTC)
- Diagnostic Trouble Code Procedures
- Symptom Chart
- Symptom Procedures
- Notes
- Inspection Procedure 1: When the Brake Pedal is Depressed, Cruise Control is not Cancelled
- Inspection Procedure 2: When the Clutch Pedal is Depressed, Cruise Control is not Cancelled < M/T. >
- Inspection Procedure 3: When the Selector Lever is Moved to "N" Position, Cruise Control is not Cancelled < CVT. >
- Inspection Procedure 4: When the Shift Lever is Moved to "N" Position, Cruise Control is not Cancelled < TC-SST. >
- Inspection Procedure 5: When the "CANCEL" Switch is Pressed, Cruise Control is not Cancelled
- Inspection Procedure 6: Cruise Control cannot be Set (No Response "COAST/SET" Switch and "ACC/RES" Switch is Pressed) (2.0L ENGINE Non-turbo, 2.4L ENGINE.)
- Inspection Procedure 7: Cruise Control cannot be Set (No Response "COAST/SET" Switch and "ACC/RES" Switch is Pressed) (2.0L ENGINE Turbo)
- Inspection Procedure 8: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed < M/T. >
- Inspection Procedure 9: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed < CVT. >
- Inspection Procedure 10: Hunting (Repeated Acceleration and Deceleration) Occurs at the Set Vehicle Speed < TC-SST. >
- Inspection Procedure 11: When the "ON/OFF" Switch is Turned ON, "CRUISE" Indicator Light does not Illuminate (However, Cruise Control System is Normal.)
- Data List Reference Table
- ECM Terminal Voltage Reference Chart For Cruise Control System Operation
- Special Tools
- On-Vehicle Service
- Cruise Control System Component Check
- Cruise Control Switch