LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2012 >> Lancer SE >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior - Lancer >> Seat Assembly >> Front Seat Assembly >> Removal Service Point >> << A >> Wiring Harness Connector Disconnection

<< A >> Wiring Harness Connector Disconnection

Disconnect the following wiring harness connectors:

FRONT SEAT WIRING HARNESS CONNECTORS

Connector number Connector name
D-27 (4 - black) Heated seat assembly connector (LH) < Vehicle with heated seat >
D-28 (2 - gray) Seat slide sensor connector (LH)
D-29 (4 - black) Seat belt switch connector (Driver's seat)
D-30 (2 - yellow) Side-airbag module (Squib) connector (LH) < Vehicles with side-airbag >
D-32 (2 - yellow) Side-airbag module (Squib) connector (RH) < Vehicles with side-airbag >
D-33 (4 - black) Seat belt switch connector (Passenger's seat)
D-34 (2 - black) Heated seat assembly connector (RH) < Vehicle with heated seat >
D-35 (6) Front seat assembly connector (RH)
Fig 1: Front Seat Assembly Wiring Harness Connector Locations
G05384610Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
NOTE: When disconnecting the side air bag module connectors of D-30 and D-32, unlock the connector by sliding the locking button to the direction of the arrow as shown in the illustration, and then disconnect the connector.
Fig 2: Disconnecting Side Air Bag Module Connector
G05396067Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.