LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle Overhaul -- Lancer >> Transaxle Case >> Disassembly And Assembly >> Assembly Service Points >> >>A<< Oil Seal Installation

>>A<< Oil Seal Installation

  1. Using special tools MB992210 and MB992075, press-fit the oil seal until the difference in height between the transaxle case and oil seal is obtained as shown.
  2. Pack grease to the oil seal lip area.

    Specified grease: 

    Mitsubishi Part No. 0101011 or equivalent 

    Fig 1: Pressing Oil Seal Using Special Tools MB992210 And MB992075
    G06672180Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Height Between Transaxle Case And Oil Seal
    G06672181Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals