LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle Overhaul -- Lancer >> Output Shaft >> Disassembly And Assembly >> Assembly SERVICEPOINTS >> >>D<< Synchronizer Ring Set No. 2 (Synchronizer Outer Ring No. 2, Synchronizer Middle Ring No. 2, Synchronizer Inner Ring No. 2) And 2ND Gear Installation

>>D<< Synchronizer Ring Set No. 2 (Synchronizer Outer Ring No. 2, Synchronizer Middle Ring No. 2, Synchronizer Inner Ring No. 2) And 2ND Gear Installation

CAUTION: The rings of the synchronizer ring set No. 1 and No. 2 are dedicated to the 1st and 2nd gears. Be sure to install the right ring set to the right gear.
  1. Make sure that the synchronizer outer ring of the synchronizer ring set No. 2 is as shown.
    Fig 1: Identifying Synchronizer Outer Ring Of Synchronizer Ring Set No. 2
    G06672154Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the synchronizer ring set No. 2 to the 2nd gear aligning the claws of the synchronizer middle ring to the positioning holes in the 2nd gear.
    NOTE: Apply gear oil to the sufficiently on the sliding surface
    Fig 2: Locating Claws Of Synchronizer Middle Ring
    G06672155Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals