LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle Overhaul -- Lancer >> Output Shaft >> Disassembly And Assembly >> Assembly SERVICEPOINTS >> >>C<< Reverse Gear And Synchronizer Hub No. 1 INSTALLTION

>>C<< Reverse Gear And Synchronizer Hub No. 1 INSTALLTION

  1. Install the reverse gear onto the synchronizer hub in the illustrated direction.
    NOTE: Apply gear oil to the sufficiently on the sliding surface
    Fig 1: Identifying Reverse Gear Installtion Direction
    G06672152Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Using special tools MD998812, MD998814 and MD998819, install the synchronizer hub and reverse gear.
  3. After installation, confirm the 1st gear slides smoothly.
    Fig 2: Installing Synchronizer Hub And Reverse Gear Using Special Tools MD998812, MD998814 And MD998819
    G06672153Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals