LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle Overhaul -- Lancer >> Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>B<< Synchronizer Hub No. 2 And Synchronizer Sleeve No. 2 Installation

>>B<< Synchronizer Hub No. 2 And Synchronizer Sleeve No. 2 Installation

  1. Before assembly, make sure that the hub and sleeve face the correct direction.
    NOTE:
    • Apply gear oil to the caulked area between the sleeve and the hub.
    • After installation, confirm the sleeve and the hub slide smoothly.
      Fig 1: Identifying Installation Direction Of Hub And Sleeve Face
      G06672138Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Using special tools MD998812, MD998813, MD998820 and MD998917, install the synchronizer sleeve No. 2 and synchronizer hub No. 2.
    Fig 2: Installing Synchronizer Sleeve No. 2 And Synchronizer Hub No. 2 Using Special Tools
    G06672139Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals