LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transaxle Diagnosis & On-Vehicle Service -- Lancer Evolution >> On-Vehicle Service >> Transmission Oil Change

Transmission Oil Change

  1. Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
  2. Remove the drain plug and gasket to drain the oil.
  3. Install the drain plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  4. Remove the filler plug and gasket, then fill the oil up to the lower edge of the oil filler plug.

    Brand name: DiaQueen NEW MULTI GEAR OIL API classification GL-3, SAE 75W-80 

    Quantity: 2.5 dm 3  (2.6 quarts) 

    Fig 1: Identifying Oil Filler Plug And Oil Drain Plug
    G05392267Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  6. Install the engine room under cover front B assembly. (Refer to UNDER COVER .)
    Fig 2: Identifying Filler Plug Hole, Filler Plug And Gasket
    G06672032Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals