Camber, Caster And Kingpin Inclination

Required Special Tool: 

• MB991004: Wheel Alignment Gauge Attachment <Vehicles with aluminum wheels>

  Standard value: 

  Camber - 0°05' ± 0°30' (Left/right deviation within 0°30') 

  Caster 2°40' ± 0°30' (Left/right deviation within 0°30') 

  Kingpin inclination 13°30' ± 1°30' 

  NOTE: Camber and caster are preset at the factory and can not be adjusted.
  CAUTION: Never subject the wheel bearings to the vehicle load when the drive shaft nuts are loosened.
  NOTE: For vehicles with aluminum type wheels, attach the camber/caster/kingpin gauge to the driveshaft by using the special tool MB991004. Tighten the special tool MB991004 to the same torque 144 - 176 N.m (106 - 130 ft-lb) as the drive shaft nut.
  Fig 1: Attaching Camber/Caster/Kingpin Gauge To Driveshaft

  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.