LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Steering >> Steering Gear >> Power Steering -- Lancer >> Power Steering Gear Box And Linkage >> Disassembly And Assembly >> Assembly Service Points >> >>C<< Tie-Rod End/Jam Nut Installation

>>C<< Tie-Rod End/Jam Nut Installation

Screw in the tie-rod to the length shown in the illustration, and hand-tighten the jam nut.

NOTE: Install the steering gear and linkage to the body, adjust the toe-in, and then tighten the jam nut to the specified torque.
Fig 1: Identifying Tie-Rod Length
G06673033Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals