LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System (SRS) -- Lancer >> Side Impact Sensor >> Removal And Installation >> Installation Service Points >> >>C<< Post-Installation Inspection

>>C<< Post-Installation Inspection

  1. Reconnect the negative (-) battery cable.
  2. Turn the ignition switch to the "ON" position.
  3. Does the "SRS" warning light illuminate for approximately seven seconds, and go out?
  4. If yes, the SRS system is functioning properly. If not, refer to DIAGNOSTIC TROUBLE CODE CHART <SRS-ECU>  .
    Fig 1: Identifying SRS Warning Light
    G06669285Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.