A/C Compressor Clutch Relay ON Conditions
A/C COMPRESSOR CLUTCH RELAY REFERENCE CHART
| Ignition switch (IG2) | ON |
NOTE:
A/C compressor clutch relay is de-energized when any one switch, sensor or control unit shown turns off.
NOTE:
The components marked by * communicate with the ECU. If the air thermo sensor detects a temperature of 1°C (33.8°F), the A/C-ECU will turn off the A/C compressor clutch relay.
|
|
| Blower switch | ON | ||
| A/C switch, mode selection dial defroster, defroster/foot position or temperature control MAX A/C | ON | ||
| Air thermo sensor | * | ||
| Pressure detected by A/C pressure sensor | 2.94 MPa (427 psi) or less (If the refrigerant pressure exceeds 2.94 MPa (427 psi), A/C compressor clutch relay is not ON condition until the refrigerant pressure has been measured up to 2.35 MPa (341 psi) a or less.) | ON | |
| 0.19 MPa (27 psi) or more (If the refrigerant pressure falls short of 0.19 MPa (27 psi), A/C compressor clutch relay is not ON condition until the refrigerant pressure has been measured up to 0.22 MPa (32 psi) or more.) | |||
| A/C compressor clutch relay driving transistor (within powertrain control module) | ON | ||