LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (General Information - Lancer Evolution) >> Maintenance Service >> 5. Spark Plugs (Replace)

5. Spark Plugs (Replace)

WARNING: This page is about a different variant/trim than selected.
CAUTION: Iridium plugs are used. Use care not to damage the iridium tips of the plugs. Do not adjust the spark plug gap.
  1. Spark plugs must spark properly to assure proper engine performance and reduce exhaust emission level.

    Therefore, they should be replaced periodically with new ones.

    Spark plug type

    SPARK PLUG GAP SPECIFICATION

    Maker Identifcation No.
    NGK ILKR8E6
    Fig 1: Identifying Spark Plug Gap
    G05392253Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. The new plugs should be checked for the proper gap.

    Spark plug gap: 0.5 - 0.6 mm (0.020 - 0.023 inch) 

  3. Install the spark plugs and tighten to 18 ± 2 N.m (13 ± 1 ft-lb).
scientia non olet · About LEMON Manuals