23. Rear Axle Oil (For Differential Part) (Change)
WARNING: This page is about a different variant/trim than selected.
- Remove the filler plug.
- Remove the drain plug and drain oil.
- Install the drain plug, and tighten it to the specified torque.
Tightening torque: 32 ± 2 N.m (23 ± 2 ft-lb)
- Fill the specified gear oil up to the bottom of the filler plug hole.
Specified gear oil: MITSUBISHI Genuine DIA QUEEN Multi gear oil LS
Amount to use: 0.55 ± 0.02 dm 3 (0.58 ± 0.02 qt)
- Install the filler plug, and tighten it to the specified torque.
Tightening torque: 49 ± 10 N.m (37 ± 7 ft-lb)