LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (General Information - Lancer Evolution) >> Maintenance Service >> 14. Transfer Oil (Check Oil Level/Change) >> Transfer Oil Change

Transfer Oil Change

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
  2. Remove the drain plug and gasket to drain the oil.
  3. Install the drain plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  4. Remove the filler plug and gasket, then fill the oil up to the lower edge of the filler plug hole.

    Brand name: DiaQueen LSD gear oil 

    Quantity: 0.8 dm 3  (0.85 quarts) 

  5. Install the filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  6. Install the engine room under cover front B assembly. (Refer to UNDER COVER .)
    Fig 1: Identifying Oil Filler Plug And Oil Drain Plug
    G05392273Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Oil Filler Plug Hole
    G06480808Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals