LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (General Information - Lancer Evolution) >> Maintenance Service >> 11. Manual Transaxle Oil (Check Oil Level And Condition/RCHANGE) >> Transaxle Oil Change

Transaxle Oil Change

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
  2. Remove the oil drain plug and gasket to drain the oil.
  3. Install the oil drain plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

    Fig 1: Identifying Oil Filler Plug And Gasket
    G05392267Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Remove the oil filler plug and gasket, then fill the oil up to the lower edge of the oil filler plug.

    Brand name: DiaQueen NEW MULTI GEAR OIL API classification GL-3, SAE 75W-80 

    Quantity: 2.5 dm 3  (2.6 quarts) 

    Fig 2: Identifying Oil Filler Plug And Gasket
    G05392268Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the oil filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  6. Install the engine room under cover front B assembly. (Refer to UNDER COVER .)
scientia non olet · About LEMON Manuals