Section 72 (MULTIPORT Fuel Injection (MFI) (2.4L) - Lancer - General Information, Introduction, Diagnostic Trouble Code & Symptom Charts)
WARNING: This page is about a different variant/trim than selected.
- Technical Information
- General Information
- General Specifications
- Service Specifications
- Sealant And Adhesive
- Special Tool
- MULTIPORT Fuel Injection (MFI) Diagnosis
- Troubleshooting Strategy
- Diagnostic Function
- Malfunction Indicator Lamp (Service Engine Soon Or Check Engine Lamp)
- How To Connect The Scan Tool (M.U.T.-III)
- How To Read And Erase Diagnostic Trouble Codes
- How To Read Data List
- How To Perform Actuator Test
- How To Diagnose The Can Bus Lines
- How To Read Provisional Diagnostic Trouble Codes
- Confirmation Method
- Permanent DTC
- Procedures For Erasing Permanent DTC
- Mode 6 Reference Table
- On-Board Diagnostics
- OBD-II Drive Cycle
- System Readiness Test Status
- Fail-Safe Function Reference Table
- Diagnostic Trouble Code Chart
- Symptom Chart