LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Overhaul <2.4L> - Lancer) >> Water Hose And Pipe >> Removal And Installation >> Installation Service Points >> >>A<< Thermostat Housing/Water Pipe Assembly/Water Pipe Gasket Installation

>>A<< Thermostat Housing/Water Pipe Assembly/Water Pipe Gasket Installation

WARNING: This page is about a different variant/trim than selected.
  1. Assemble the thermostat housing and water pipe
  2. Install the thermostat housing gasket.
  3. Install a new water pipe gasket so that the tab is positioned as shown in the illustration.
  4. Temporarily tighten them to the cylinder head and water pump. Then tighten them to the specified torque.

    Specified torque: 24 ± 3 N.m (18 ± 1 ft-lb) 

    Fig 1: Locating Thermostat Housing/Water Pipe Assembly/Water Pipe Gasket Tab
    G06665281Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals