LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Overhaul <2.4L> - Lancer) >> Timing Chain >> Removal And Installation >> Installation Service Points >> >>D<< Timing Chain TENSIONER Installation

>>D<< Timing Chain TENSIONER Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the timing chain tensioner on the cylinder block and tighten it to the specified torque.

    Tightening torque: 10 ± 2 N.m (89 ± 17 in-lb) 

  2. Remove the hard wire (piano wire or the like) of f1.5 or hexagonal bar wrench (1.5 mm [0.05 inch]) from the timing chain tensioner. This enables the plunger of the timing chain tensioner to push the tensioner lever to keep the timing chain tight.
    Fig 1: Identifying Ratchet Release Hole, Wire And Plunger Fixed Hole
    G06665311Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals