Special Tools
WARNING: This page is about a different variant/trim than selected.
SPECIAL TOOL DESCRIPTION CHART
| Tool | Tool number and name | Supersession | Application |
|---|---|---|---|
| MB991883 Flywheel stopper |
- | Securing of drive plate | |
| MB991398 Spark plug wrench |
- | Removal and installation of spark plug | |
| MB992106 O-ring installer |
- | Installation of O-ring on injector injection nozzle side | |
| MB991396 Oil filter wrench |
- | Removal and installation of oil filter | |
| MD998727 Oil pan FIPG cutter |
MD998727-01 | Removal of oil pan | |
| MB991448 Bushing remover and installer base |
MB991448-01 | Press fit of front oil seal | |
| MD998735 Valve spring compressor |
MD998735-01 | Compression of valve spring | |
| MB992089 Retainer holder C |
MB992089-01 | ||
| MB992085 Valve stem seal pliers |
- | Extraction of valve stem seal | |
| MD998737 Valve stem seal installer |
MD998737-01 | Installation of valve stem seal | |
| MD998780 Piston pin setting tool |
MIT216941 | Extraction and press fit of piston pin | |
| MB991659 Guide D |
- | ||
| MB991614 Angle gauge |
General service tool | Installation of crankshaft bearing cap bolt and installation of balancer shaft module bolt | |
| MD998718 Rear oil seal installer |
MD998718-01 | Press fit of rear oil seal |