Section 7 (Engine Overhaul <2.4L> - Lancer): Sealants: Notes
WARNING: This page is about a different variant/trim than selected.
SEALANTS SPECIFICATION CHART
| Points of application | Specified sealant/adhesive |
|---|---|
| Drive plate bolt | Three bond 1324 or equivalent |
| Oil pan | Three bond 1227D, Three bond 1217G (Mitsubishi Part No,1000A923), Three bond 1207F (Mitsubishi Part No,1000A992), LOCTITE 5971, LOCTITE 5900, LOCTITE 5970 or equivalent |
| Cylinder head cover (matching area of the cylinder head and the timing chain case assembly) | Three bond 1227D, Three bond 1217G (Mitsubishi Part No,1000A923), or equivalent |
| Ladder frame | |
| Cylinder head gasket (matching area of the cylinder block and the cylinder head) | Three bond 1217G (Mitsubishi Part No,1000A923), or exact equivalent |
| Timing chain case | |
| Engine coolant temperature sensor | Three bond 1324N, LOCTITE 262 or equivalent |
| Engine oil pressure switch | Three bond 1212D, Three bond 1215 or equivalent |
NOTE:
The number in square brackets shows the part number.