LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Overhaul <2.4L> - Lancer) >> Intake Manifold And Fuel System >> Removal And Installation >> Installation Service Points >> >>C<< Intake Manifold Installation

>>C<< Intake Manifold Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: Temporarily tighten the inlet manifold because there is a bolt tightening procedure for the inlet manifold, delivery pipe and injector protector.

Tighten each inlet manifold bolt and nut to the temporarily torque of 3.5 ± 1.5 N.m (31 ± 13 in-lb).

scientia non olet · About LEMON Manuals