>>B<< Exhaust Manifold Bracket Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
The exhaust manifold gasket, washers and nuts must not be reused.
Make sure that exhaust manifold bracket A is in intimate contact with the exhaust manifold and cylinder block, and then tighten it to the specified tightening torque.
Tightening torque:
M10 x 30: 41 ± 10 N.m (30 ± 7 ft-lb)
M8 x 20: 20 ± 5 N.m (15 ± 3 ft-lb)