LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Overhaul <2.4L> - Lancer) >> Exhaust Manifold >> Removal And Installation >> Installation Service Points >> >>A<< Crankshaft Position Sensor/O-Ring Installation

>>A<< Crankshaft Position Sensor/O-Ring Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not apply a force such as torsion or twist to the O-ring during assembly of the sensor.
  • Assemble the sensor, taking care not to give a shock to it.
  • Do not use a sensor that has fallen down.

Tighten the crankshaft position sensor to the specified tightening torque of 11 ± 1 N.m (98 ± 8 in-lb).

scientia non olet · About LEMON Manuals