LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Overhaul <2.4L> - Lancer) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >>B<< Thrust Bearing Installation

>>B<< Thrust Bearing Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the thrust bearing on the Number 3 bearing on the cylinder block side. Application of engine oil makes the installation easy.
  2. Install the thrust bearing so that the grooved side is on the crankshaft weight side.
    Fig 1: Identifying Thrust Bearing Groove
    G06665404Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals