LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Overhaul <2.4L> - Lancer) >> Crankshaft And Cylinder Block >> Removal And Installation >> Installation Service Points >> >>A<< Crankshaft Sensing Ring Installation

>>A<< Crankshaft Sensing Ring Installation

WARNING: This page is about a different variant/trim than selected.

Tighten crankshaft sensing ring bolts to the torque of 11 ± 1 N.m (98 ± 8 in-lb) in the tightening order shown in the illustration.

Fig 1: Identifying Crankshaft Sensing Ring Bolts Tightening Sequence
G06665403Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals