LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Overhaul <2.4L> - Lancer) >> Balancer Chain >> Removal And Installation >> Installation Service Points >> >>E<< Drive Plate/Flywheel Bolt Installation

>>E<< Drive Plate/Flywheel Bolt Installation

WARNING: This page is about a different variant/trim than selected.
  1. Clean off sealant and oil of thread of crankshaft and drive plate bolt or flywheel bolt.
  2. Use special tool MB991883 to secure the drive plate or flywheel.
    Fig 1: Securing Flywheel Using Special Tool MB991883
    G06665376Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Apply engine oil to thread of crankshaft and bolt seat area of drive plate or flywheel.
  4. Apply the sealant to the thread of drive plate bolt or flywheel bolt.

    Specified sealant: 

    Three bond 1324 or equivalent 

    Fig 2: Applying Sealant To Thread Of Drive Plate Bolt Or Flywheel Bolt
    G06665377Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Tighten drive plate bolt or flywheel bolt to temporary torque of 40 N.m (32 ft-lb) in the order shown to illustration.
  6. Tighten drive plate bolt or flywheel bolt to specified tightening torque of 130 N.m(95 ft-lb) in the order shown in the illustration.
    Fig 3: Identifying Flywheel Bolts Tightening Sequence
    G06665378Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals