Section 65 (MULTIPORT Fuel Injection (MFI) - Lancer Evolution - General Information, Introduction, Diagnostic Trouble Code & Symptom Charts)

• General Information
  • Notes
  • Fuel Injection Control
  • Throttle Valve Opening Control
  • Idle Air Control
  • Ignition Timing Control
  • Diagnostic Test Mode
  • Other Control Functions
    • Fuel Pump Control
    • A/C Compressor Clutch Relay Control
    • Engine Oil Control Valve Control
    • Intake Charge Pressure Control
    • Generator Output Current Control
    • Evaporative Emission Purge Control
  • MULTIPORT Fuel Injection (MFI) System Diagram
• General Specifications
• Service Specifications
• Sealant And Adhesive
• Special Tool
• MULTIPORT Fuel Injection (MFI) Diagnosis
  • Troubleshooting Strategy
  • Diagnostic Function
    • Malfunction Indicator Lamp (Service Engine Soon Or Check Engine Lamp)
    • How To Connect The Scan Tool (M.U.T.-III)
    • How To Read And Erase Diagnostic Trouble Codes
    • How To Read Data List
    • How To Perform Actuator Test
    • How To Diagnose The Can Bus Lines
    • How To Read Provisional Diagnostic Trouble Codes
    • Confirmation Method
    • Permanent DTC
    • Procedures For Erasing Permanent DTC
    • Mode 6 Reference Table
    • On-Board Diagnostics
    • OBD-II Drive Cycle
      • Notes
      • Drive Cycle Pattern List
      • Pattern 1
      • Pattern 2
      • Pattern 3
      • Pattern 4
      • Pattern 5
      • Pattern 6
      • Pattern 7
      • Pattern 8
      • Pattern 9
      • Pattern 10
      • Pattern 11
      • Pattern 12
      • Pattern 13
      • Pattern 14
      • Pattern 15
      • Pattern 16
      • Pattern 17
      • Pattern 18
      • Pattern 19
      • Pattern 20
      • Pattern 21
      • Pattern 22
      • Pattern 23
    • System Readiness Test Status
      • Purpose
      • Overview
  • Fail-Safe Function Reference Table
  • Diagnostic Trouble Code Chart
  • Symptom Chart
    • Notes
    • Problem Symptoms Table (For Your Information)