LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Twin Clutch-SPORTRONIC Shift Transmission Overhaul -- Lancer) >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >>A<< Manual Control Shaft Installation

>>A<< Manual Control Shaft Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the manual control shaft carefully and tighten the screw to the specified torque.

    Tightening torque: 10 ± 1.5 N.m (89 ± 8 in-lb) 

    Fig 1: Identifying Transaxle Case Screw
    G06672219Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Tighten the plug to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

    Fig 2: Tightening Plug
    G06672220Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals