LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 58 (Headlight -- Lancer Evolution) >> On-Vehicle Service >> Replace The Bulb >> Position Light Bulb Replacement

Position Light Bulb Replacement

WARNING: This page is about a different variant/trim than selected.
  1. When replacing the right bulb, lift the radiator condenser tank upward, and remove it. When replacing the left bulb, remove the relay box. <Vehicles without discharge headlight>
    Fig 1: Identifying Radiator Condenser Tank
    G05396824Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Identifying Relay Box
    G05396825Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Remove the front splash shield assembling clip shown in the illustration, and turn up the front splash shield. <Vehicles with discharge headlight>
    Fig 3: Locating Front Splash Shield
    G05396831Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Twist the position light socket to remove.
    Fig 4: Locating Position Light Socket
    G05385316Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals