LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 48 (Trunk Lid -- Lancer Evolution) >> On-Vehicle Service >> Trunk Lid Height Adjustment >> Adjustment At Body-Side

Adjustment At Body-Side

WARNING: This page is about a different variant/trim than selected.

If the height between the trunk lid and the body is uneven, adjust the height in the following manner.

  1. Loosen the body-side trunk lid hinge mounting bolts.
  2. Adjust the height.
  3. Tighten the hinge mounting bolts

    Specified torque: 23 ± 6 N.m (17 ± 4 ft-lb) 

    Fig 1: Adjusting Trunk Lid Height Adjustment
    G05384191Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals