Removal And Installation: Notes

WARNING: This page is about a different variant/trim than selected.

CAUTION: When the door lock cylinder of the vehicle with WCM is replaced as a full service key set, the key must be registered with the barcode No. attached to the ignition key. (Refer to ID CODE REGISTRATION CRITERIA TABLE .)

Fig 1: Front Door Handle And Latch Replacement Components With Torque Specifications

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Rear Door Handle And Latch Replacement Components With Torque Specifications

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Required Special Tool:

T-type Long Torx Wrench (T30)