INSPECTION PROCEDURE 1: Difficult Locking and Unlocking: Diagnosis

WARNING: This page is about a different variant/trim than selected.

STEP 1. Check that the release cable is routed correctly.
Q: Is the release cable routed correctly?
- YES: Go to Step 2.
- NO: Re-route the release cable. Then go to Step 4.
STEP 2. Check the engagement of the hood latch and hood striker.
Q: Are the hood latch and hood striker engaged correctly?
- YES: Go to Step 3.
- NO: Adjust the hood latch (Refer to ALIGNMENT OF HOOD LATCH AND STRIKER ). Then go to Step 4.
STEP 3. Check for proper lubrication of release cable.
Q: Is the release cable properly lubricated?
- YES: Go to Step 4.
- NO: Lubricate, then go to Step 4.
STEP 4. Retest the system.
Q: Does the hood lock operate easily?
- YES: The procedure is complete.
- NO: Return to Step 1.